Q: I have a pair of breathable waders that have a small, slow leak where the boots meet the material. If using your product, SG-20 Adhesive, how would I apply it to the seam from the inside like you state for breathable waders? The boot does not bend to get a good application. Or could one just apply it on the outside seam? - D.R.
A: If the area, in question, is the breathable wader material we would not try to fix the leak there as it will not totally bond. This is because the breathable wader material is covered with a water resistant coating that SG-20 doesn't adhere to. Instead, we would suggest turning the waders inside out as much as possible to access the area. You should be able to hit that area with the mix tip and then cover it with the pink plastic included in the kit. If you can't reach the area with your mixing tip, then put enough material on the plastic and quickly place the plastic over the leak. Hold it there for 30 seconds, wait about 15 minutes, and then you can peel the plastic off. We hope that helps. Click HERE to see a video on applying SG-20 Adhesive to breathable waders. - F.R., Vettec, Inc.